Alabama ALEA CDL General Knowledge Practice Test 6
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. Besides allowing the move at all, what does an oversize load permit usually set out?
Show answer
Answer C: The route to be followed, the hours of travel allowed and the warning equipment needed
Permits for oversize movements normally name the roads that may be used, restrict the times of travel, and list the flags, signs and escorts required.
-
2. How do you avoid the sharp lurch that comes at the very end of a stop in a heavy vehicle?
Show answer
Answer A: Ease off the brake pressure just before the vehicle actually comes to rest
A smooth stop is finished by reducing pedal pressure as the vehicle settles, so the suspension does not rock the cab and the load forward.
-
3. What color must the clearance and side marker lamps and reflectors at the front of a trailer be?
Show answer
Answer A: Amber
Amber marks the front and the forward part of the sides of a vehicle, while red marks the rear, so another driver can tell which way the vehicle is facing.
-
4. You are stopped in a line of traffic behind a car. How much space should you leave in front of you?
Show answer
Answer C: Enough to see where the rear tires of that car meet the road
That amount of space lets you pull around the vehicle ahead if it stalls and absorbs some of the shock if you are struck from behind.
-
5. You are backing a tractor-trailer in a straight line and the trailer starts to drift to the left. What is the standard correction?
Show answer
Answer D: Turn the top of the steering wheel a little to the left, toward the drift
Small corrections made in the direction the trailer is drifting bring it back into line; large or opposite movements make the drift worse.
-
6. Most rollovers of loaded trucks on exit and entrance ramps happen for which reason?
Show answer
Answer B: The ramp was taken faster than the load could tolerate
A posted ramp speed is set for cars, and a loaded trailer with a high center of gravity can roll at a speed a car would take easily.
-
7. How long is an Alabama commercial learner permit valid, and can it be renewed?
Show answer
Answer B: 360 days, and it cannot be renewed
The Alabama CLP is valid for 360 days and is not renewable, so once it expires the applicant must retake all the written tests and be issued a new permit.
-
8. Which items belong to the in-cab part of the inspection?
Show answer
Answer D: Gauges, controls, mirrors, windshield, wipers, horn, heater and defroster
The in-cab step checks the instruments and controls the driver depends on, along with mirrors, glass, wipers, horn and the heater and defroster.
-
9. How soon must warning devices be placed after a commercial vehicle stops on the traveled part or the shoulder of a highway?
Show answer
Answer D: As soon as possible and in any case within 10 minutes
The hazard warning flashers go on immediately and the warning devices must be in place as soon as possible, never later than 10 minutes after stopping.
-
10. An article of cargo has been blocked so that it cannot move forward. How many tiedowns does the federal rule call for?
Show answer
Answer A: One tiedown for every 10 feet of article length, or any part of that
Blocking against forward movement lowers the requirement to one tiedown per 10 feet of length or fraction of 10 feet.
-
11. What do the U-bolts on a leaf spring suspension do?
Show answer
Answer A: They clamp the spring assembly to the axle so it cannot move
U-bolts hold the spring pack tight against the axle, and a loose or broken U-bolt lets the axle slide out of place under load.
-
12. Which exhaust system condition must be reported as a defect?
Show answer
Answer B: A section repaired by wrapping tape or patching material around the pipe
Exhaust parts may not be patched with wrap or tape, because the repair does not contain the gas or the heat and it fails quickly in service.
-
13. An Alabama applicant qualifies for the military skills test waiver. What testing still applies?
Show answer
Answer D: The applicant must still take the CDL knowledge tests
Alabama can waive the skills test for qualifying service members, but the applicant must still pass the knowledge portions of the CDL examination.
-
14. Which description matches controlled braking during an emergency stop?
Show answer
Answer D: Apply the brakes as hard as you can without locking the wheels and keep steering movements small
Controlled braking keeps the wheels rolling just short of lockup, which gives the shortest stop while you keep the ability to steer.
-
15. When speed doubles, what happens to braking distance?
Show answer
Answer D: It becomes roughly four times as long
Braking distance rises with the square of speed, so twice the speed needs about four times the distance to stop.
-
16. When should the horn of a commercial vehicle be used?
Show answer
Answer C: Only when it is needed to avoid a crash
An air horn is loud enough to startle other road users, so it is a warning device rather than a way to comment on other drivers.
-
17. You are drifting in the lane, yawning constantly and cannot remember the last few miles. What is the only reliable cure?
Show answer
Answer C: Stopping in a safe place and sleeping
Those are classic drowsiness warning signs, and nothing except sleep repays the sleep the body is missing.
-
18. The combined working load limit of the tiedowns on a load must equal at least what share of the cargo weight?
Show answer
Answer C: One half of the cargo weight
Federal securement rules set the aggregate working load limit at no less than half the weight of the article or group of articles being held.
-
19. What tells you that an air suspension bag has a problem?
Show answer
Answer B: The bag is leaking or damaged, or the vehicle sits unevenly on that side
An air bag that leaks or is cut lets that corner of the vehicle settle, which throws the load onto the other suspension parts and changes the ride height.
-
20. What makes a brake hose or air line a defect during the walkaround?
Show answer
Answer D: It is cracked, worn, kinked, or rubbing against another part
A chafed or cracked line can burst under pressure and take the braking on that circuit with it, so damage and rubbing points must be corrected.
-
21. What is the payload of a truck?
Show answer
Answer C: The weight of the cargo the vehicle is carrying, that is the loaded weight less the empty weight
Payload is what is left of the legal or rated weight once the weight of the empty vehicle is taken off, and it is the weight of cargo that can be carried.
-
22. You hear air escaping from a trailer tire during the pre-trip. What should you do?
Show answer
Answer C: Have it repaired or replaced before the vehicle is driven
An audible leak means the tire is failing now, and federal rules do not allow a vehicle to be operated on a flat or leaking tire.
-
23. At what time of day do drowsy driving crashes occur most often?
Show answer
Answer A: Between midnight and 6 a.m.
The body clock makes people sleepiest in the early morning hours, which is when most fatigue-related crashes happen.
-
24. Your load projects more than 4 feet beyond the rear of the vehicle. How must the projecting end be marked?
Show answer
Answer A: With a red or orange flag by day and a red lamp after dark
Federal rules require a warning flag on a rear projecting load in daylight and a red lamp on the end of it when lights are required.
-
25. How is a shipping container normally secured when it is carried on a special container chassis?
Show answer
Answer B: With its own locking devices that attach the container directly to the chassis frame
Containers built for rail or ship transport have locking corners that fasten to a matching chassis; a container carried on a plain flatbed must be secured like any other cargo.
-
26. Why does a heavy vehicle need a much larger gap than a car in order to cross or enter traffic?
Show answer
Answer C: Because it accelerates slowly and needs far more road and time to clear the intersection
Slow acceleration combined with the length of the vehicle means a gap that would feel comfortable in a car is nowhere near enough.
-
27. Which components on a typical engine are driven by belts that must be checked for wear and tension?
Show answer
Answer D: The alternator, the water pump and, on many vehicles, the air compressor
Belts drive accessories such as the alternator, the water pump and the air compressor, so one failed belt can take out charging, cooling or air supply.
-
28. At a rest area you find that the load has shifted although the straps still feel tight. What should you do?
Show answer
Answer C: Correct the load before driving on, since a shifted load is no longer secure
Movement means the securement has already failed once, and a load that has shifted can shift again, so it is put right before the vehicle moves.
-
29. A strap is a little too long, so a driver ties a knot in it to take up the slack. Is that acceptable?
Show answer
Answer C: No, tiedowns must not contain knots
A knot destroys the rated strength of a tiedown, so the rules do not allow knotted securement devices; the excess is taken up by the winch or ratchet instead.
-
30. After the first inspection of a trip, how often must cargo securement be checked again?
Show answer
Answer D: Every 3 hours or 150 miles or at each change of duty status, whichever happens first
The load must be re-checked at whichever of those points arrives first, so a loosening tiedown is found long before it fails.
-
31. When is tire pressure most accurately compared with the recommended figure?
Show answer
Answer B: When the tires are cold, before the vehicle has been driven
Recommended pressures are cold pressures, so a reading taken before the tires have heated up is the only one that can be compared directly.
-
32. What should you look for on the electrical wiring in the engine compartment?
Show answer
Answer A: Worn, frayed or cracked insulation and loose or corroded connections
Damaged insulation can short a circuit against the frame or engine, which can kill a lamp you depend on or start a fire.
-
33. You must drive well below the speed of surrounding traffic, for example when climbing a steep grade with a heavy load. What should you do?
Show answer
Answer B: Turn on the four-way flashers to warn following traffic, where state law allows it
Flashers warn faster traffic that a slow-moving vehicle is ahead, which helps prevent rear-end crashes; some states restrict their use while moving, so check the local rule.
-
34. A car ahead of you keeps drifting within its lane and moving unevenly. What should you assume?
Show answer
Answer C: The driver may be distracted, lost or impaired
Unsteady lane keeping is a classic clue to a driver who is not in full control, so the safe response is to keep back and give plenty of room.
-
35. What does the driver check in the final step of the seven-step inspection?
Show answer
Answer A: Hydraulic brake leaks where those brakes are fitted, then the parking brake and the service brakes
The last step is done with the engine started: test for hydraulic leaks on vehicles with hydraulic brakes, then prove that the parking brake holds and that the service brakes stop the vehicle.
-
36. The engine oil pressure gauge falls toward zero while you are driving. What should you do?
Show answer
Answer C: Stop as soon as it is safe to do so and shut the engine down
Loss of oil pressure destroys an engine in a very short time, so the correct response is to stop and shut down rather than to drive on.
-
37. A placarded vehicle is carrying explosives or flammable liquids in Alabama. What maximum speed applies to it?
Show answer
Answer B: 55 mph
Alabama forbids any vehicle transporting placarded explosives, flammable liquids or hazardous wastes from exceeding 55 miles per hour at any time.
-
38. How does a load carried high in the trailer affect safe speed through a curve?
Show answer
Answer B: It raises the rollover risk, so the speed must be lower
A high center of gravity lets the vehicle tip long before the tires lose their grip, so height of the load directly limits curve speed.
-
39. Why must the driver of a large vehicle keep it centered in its lane?
Show answer
Answer B: The vehicle needs the full width of the lane
A commercial vehicle is close to lane width already, so any drift takes part of the vehicle into the next lane or onto the shoulder.
-
40. What is the purpose of the header board, or headache rack, that you inspect behind the cab?
Show answer
Answer A: It protects the driver from cargo that shifts forward during a hard stop
In a hard stop the load keeps moving forward, and the header board is the barrier between that load and the back of the cab.
-
41. The brake pedal goes to the floor in a vehicle with hydraulic brakes. What can you do to build some braking pressure?
Show answer
Answer B: Pump the brake pedal rapidly, which may bring back enough pressure to slow the vehicle
Pumping can restore some hydraulic pressure; along with downshifting and the parking brake it is one of the ways to stop when the pedal fails.
-
42. An unblocked crate 4 feet long and weighing 900 pounds needs at least how many tiedowns?
Show answer
Answer D: One
An article 5 feet or less in length and 1,100 pounds or less in weight is covered by a minimum of one tiedown.
-
43. Under Alabama law, at what blood alcohol content is a commercial vehicle operator in violation of the DUI statute?
Show answer
Answer B: 0.04 percent or more
Alabama sets a commercial driver threshold of 0.04 percent, half the 0.08 percent limit that applies to other adult drivers.
-
44. Rust streaks are running outward from the lug nuts on one wheel. What does this most likely indicate?
Show answer
Answer C: The lug nuts may be loose
Rust trails spreading from the nuts are a classic sign that the nuts have worked loose and the wheel has been moving on the studs.
-
45. Why is a quick lane change particularly risky with a load of hanging meat or of livestock?
Show answer
Answer A: The load swings or leans and can keep pushing the trailer after you straighten out
A swinging or leaning load keeps moving after the vehicle has finished the maneuver, so its momentum acts on the trailer at the worst moment.
-
46. What must the motor carrier do about a defect listed on a driver vehicle inspection report?
Show answer
Answer D: Repair it, or certify that repair is not needed, before the vehicle is dispatched again
A reported defect must be corrected, or certified as not needing correction, and that certification is what the next driver reads before taking the vehicle.
-
47. Where should a driver expect fog to form first?
Show answer
Answer D: In low ground, near water and in valleys
Cool moist air settles in low places, so fog patches appear in hollows, river valleys and near lakes before they appear anywhere else.
-
48. You drive a 40 foot straight truck at 50 miles per hour in good conditions. What following distance does the rule of thumb call for?
Show answer
Answer A: 5 seconds
One second for every 10 feet of vehicle length gives 4 seconds, and one extra second is added for speeds above 40 miles per hour.
-
49. An unblocked crate 4 feet long and weighing 1,500 pounds needs at least how many tiedowns?
Show answer
Answer A: Two
A short article that weighs more than 1,100 pounds requires at least two tiedowns even though it is under 5 feet long.
-
50. What tells a driver when to shift up in a vehicle with a manual transmission?
Show answer
Answer C: Engine speed in rpm together with road speed
Shift points are judged from engine rpm and road speed, using the operating range the manufacturer specifies for that engine.