Alabama ALEA CDL General Knowledge Practice Test 7
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. A dock crew loads and straps the freight. Who is responsible for the load being legal and secure on the road?
Show answer
Answer D: The driver
Even when someone else loads and secures the freight, the driver must inspect it and remains responsible for it while driving.
-
2. What should be done before a night trip to get the most from your headlights?
Show answer
Answer C: Clean the windshield, the mirrors and the lights
Dirt on glass and lenses cuts both the light you throw down the road and the light that reaches your eyes, so cleaning is the cheapest night safety measure there is.
-
3. For a modern truck with low-friction parts and a streamlined shape, which gear should be used going down a grade?
Show answer
Answer D: A gear lower than the one needed to climb the same grade
Newer trucks roll more freely than older ones, so the old rule of using the climbing gear no longer holds; a lower gear is needed for enough engine braking.
-
4. Under the federal air brake standard, the low air pressure warning must come on before reservoir pressure drops below what level?
Show answer
Answer A: Before pressure falls below 60 psi
Federal Motor Vehicle Safety Standard 121 requires the warning to operate while service reservoir pressure is still above 60 psi, which leaves enough air to bring the vehicle to a normal stop.
-
5. Besides slowing down, which technique most reduces the risk of a skid on a snow covered road?
Show answer
Answer B: Make every steering, braking and speed change gradual
Traction is limited on snow, and sudden inputs demand more grip than the surface can supply, so smoothness is what keeps the tires attached to the road.
-
6. While you are driving, what should you do to catch a developing problem with the vehicle?
Show answer
Answer A: Check the gauges regularly and pay attention to unusual sounds, smells or vibrations
Inspection continues during the trip: gauges, mirrors and your senses can reveal a problem long before a warning light does.
-
7. How is free play in the steering wheel measured during the inspection?
Show answer
Answer B: By turning the wheel until the front wheels just start to move and noting the movement
Play is the movement at the rim that produces no movement at the road wheels, so it is measured by turning until the wheels first respond.
-
8. During a right turn in a tractor-trailer, what are you looking for in the right hand mirror?
Show answer
Answer B: Whether the trailer will clear the curb and whether anything has moved alongside you
The right mirror is what tells you how close the trailer wheels are running to the curb and whether a vehicle or a cyclist has slipped into the space on your right.
-
9. How are the extra gears of a multi-speed rear axle or auxiliary transmission usually controlled?
Show answer
Answer D: With a selector knob or switch on the gearshift lever of the main transmission
A range selector on the shift lever lets the driver choose the extra gear range while shifting the main transmission.
-
10. An automatic transmission is left in its normal drive position as the vehicle rolls down a long grade. What does it tend to do?
Show answer
Answer A: Shift up as road speed rises, so engine braking falls away
An automatic left in drive keeps upshifting as speed builds, which is the opposite of what you want on a grade; that is why the driver must select a low range.
-
11. You pick up a sealed trailer at a shipper. What should you check before leaving the dock?
Show answer
Answer B: That the seal number matches the paperwork and that the doors are properly closed
You cannot look at a sealed load, but you can confirm that the seal is intact, that its number matches the documents and that the doors are secure.
-
12. Total stopping distance is made up of which parts?
Show answer
Answer A: Perception distance, reaction distance and braking distance
The vehicle travels while the hazard is recognized, while the driver moves to the pedal, and again while the brakes slow the vehicle.
-
13. You are hauling a load of steel plate that is well within every weight limit but is stacked five feet high on a flatbed. What is the main concern?
Show answer
Answer A: The center of gravity is high, so the rig will roll more easily in a curve
Legal weight does not make a load safe; height raises the center of gravity and it is height, not weight alone, that decides how readily the vehicle rolls over.
-
14. A driver hauling a sealed trailer that cannot be opened is still responsible for what?
Show answer
Answer D: Making sure the rig is not over the gross or axle weight limits
A seal prevents inspecting the contents, but the driver must still confirm the vehicle is not overloaded.
-
15. You have stopped and a pedestrian is waiting to cross in front of your truck. Why should you not wave the person across?
Show answer
Answer C: Another driver may not stop, and your wave sends the person into danger
You cannot control what drivers in the other lanes will do, so you should not invite a pedestrian into a lane you do not command.
-
16. What does the gross combination weight rating cover?
Show answer
Answer B: The maximum loaded weight of the power unit together with the trailer or trailers it tows
The combination rating takes in the power unit and everything behind it, loaded, as specified by the manufacturer.
-
17. Why should the mirrors be checked repeatedly while you make a tight turn?
Show answer
Answer C: To watch the rear of the vehicle clear other vehicles and objects
In a long vehicle the rear wheels cut inside the path of the front wheels, so only the mirrors show whether the rear is clearing curbs, poles and other vehicles.
-
18. You are entering a freeway from a short ramp with a fully loaded trailer. What should you do?
Show answer
Answer A: Begin building speed early and wait for a large gap
A loaded vehicle accelerates slowly, so it needs both a running start and a much larger gap than a car would use.
-
19. You pick up a trailer that another driver dropped in the yard. What must you do before pulling it?
Show answer
Answer B: Inspect it yourself, because you are responsible for the whole vehicle you drive
Responsibility follows the driver who moves the vehicle, and a trailer that has stood in a yard may have lost air, developed a flat tire or been damaged.
-
20. How does overloading affect the way a vehicle drives?
Show answer
Answer C: It slows the vehicle on upgrades, makes stopping take longer and can overheat the brakes on downgrades
Extra weight demands more from the engine and the brakes, so the vehicle climbs slowly and needs much more distance to stop.
-
21. You need to pull off onto the shoulder because of a problem with the load. How should you communicate that to other drivers?
Show answer
Answer D: Signal the move, then switch on the four-way flashers once stopped
Other drivers need a signal before you leave the lane and a clear warning once the vehicle is stopped near the traffic lanes.
-
22. What must the driver check about the seat belt during the inspection?
Show answer
Answer A: That it is securely mounted, adjusts properly and is not ripped or frayed
A belt only restrains the driver if its anchorage is sound and the webbing is intact, so mounting and condition are both checked.
-
23. You can see a crack in a brake drum that runs across more than half the width of the friction surface. What does this mean?
Show answer
Answer C: The drum is defective and must be repaired before the vehicle is driven
Cracks longer than half the width of the friction area mean the drum can break apart under braking heat and must be replaced.
-
24. Besides the hours when the law requires them, when should headlights be switched on?
Show answer
Answer A: Any time visibility is poor, such as in rain, fog or at dusk
Headlights are used to be seen as much as to see, so they belong on whenever light or weather makes the vehicle harder to spot.
-
25. Why does a driver use pull-ups while backing into a tight space?
Show answer
Answer C: To pull forward and start the approach again when the angle is going wrong
Stopping, pulling ahead and repositioning fixes a bad angle safely, and there is nothing wrong with needing more than one attempt.
-
26. Part of your load stands high enough to hide a rear lamp or a reflector. What must be done?
Show answer
Answer B: The load must be moved or extra lamps fitted so the required lights can be seen
Required lamps and reflectors must remain visible; if the cargo blocks them, the load is rearranged or additional lamps are fitted so the vehicle can still be seen.
-
27. Under federal rules, what happens to a commercial driver found with any detectable amount of alcohol while operating a commercial vehicle?
Show answer
Answer D: The driver is placed out of service for 24 hours
Any measurable alcohol takes a commercial driver off the road for 24 hours, and a concentration of 0.04 percent or more brings a disqualification.
-
28. Around a tractor-trailer, where are the blind areas that other drivers most often sit in unseen?
Show answer
Answer A: Along the right side and directly behind the trailer
The blind areas to the right of the cab and behind the trailer are the largest, which is why other drivers should never linger there.
-
29. What is the coupling device weight rating on a vehicle?
Show answer
Answer A: The most weight that the coupling on the vehicle is rated to pull
The coupling device rating is a limit on how much weight the coupling may tow, and it is one of the ratings that has to be respected when a combination is loaded.
-
30. Which document must be available to show that the annual inspection was carried out?
Show answer
Answer C: The inspection report or a copy of it, or a decal displayed on the vehicle
Proof of the periodic inspection travels with the vehicle, either as the report itself or as the decal fixed where an inspector can see it.
-
31. Federal rules require a power unit that is not carrying placarded hazardous materials to have a fire extinguisher with which minimum rating?
Show answer
Answer A: One rated 5 B:C or more, or two rated 4 B:C or more each
The minimum is a single unit rated 5 B:C or more, or two units of at least 4 B:C each, which is enough to attack a fuel or electrical fire.
-
32. You must leave the vehicle parked on a slight grade. What adds security beyond setting the parking brake?
Show answer
Answer D: Chocking the wheels so the vehicle cannot roll if the brake bleeds off
Chocks hold the vehicle mechanically and are the standard backup whenever a parked vehicle could roll.
-
33. Why is a sudden, sharp lane change dangerous in a loaded heavy vehicle?
Show answer
Answer D: The vehicle can lean far enough to roll over, especially when the load sits high
A quick swerve throws the weight of a tall, heavy load sideways, and a rollover can begin before the tires ever slide.
-
34. What is the danger of letting engine speed climb past the top of the rated rpm range before you shift?
Show answer
Answer B: You can damage the engine, so the shift should be made before that point
Every engine has a rated operating range; running above it can cause serious engine damage, so the upshift belongs at the top of that range, not beyond it.
-
35. A dispatcher tells you to take a trailer you believe is loaded badly enough to be unsafe. What should you do?
Show answer
Answer C: Refuse to move it until the load has been made safe
The driver may not operate a vehicle whose cargo is not properly distributed and secured, and an instruction from an employer does not change that.
-
36. Why must the steering wheel be moved only a small amount at a time while backing?
Show answer
Answer B: Because a small turn of the wheel produces a large change at the rear of the vehicle
In reverse, the effect of the steering is greatly magnified at the back of the vehicle, so a small correction is usually all that is needed.
-
37. During uncoupling, when may the fifth wheel locking lever be released?
Show answer
Answer D: Only after the landing gear is down and taking the weight of the trailer
The landing gear has to be supporting the trailer before the lock is released; otherwise the trailer nose can drop as soon as the tractor pulls out.
-
38. The shipper hands you the placards for a load that needs them. Who puts them on the vehicle?
Show answer
Answer C: The driver, who must also make sure they are the correct ones and are readable
The shipper supplies the placards, but it is the driver who must place them on the vehicle and confirm that they match the load and can be read.
-
39. Why should the radio, the fan and other noisy equipment be switched off during a required stop at a railroad crossing?
Show answer
Answer C: So that an approaching train can be heard
The rules require the driver to look and listen along the track, and on a double track crossing a passing train can hide a second one, so hearing matters as much as seeing.
-
40. You are given a ratchet strap with a deep cut along one edge. What should you do?
Show answer
Answer C: Do not use it; a damaged tiedown cannot be relied on to hold its rated load
Cuts, burns, knots and broken stitching weaken a strap far below its marked working load limit, so it must be taken out of service.
-
41. What does the commercial driver manual tell you to do with the parking brake when you leave your vehicle?
Show answer
Answer B: Apply the parking brake every time you leave the vehicle
The manual is explicit that the parking brake goes on whenever the driver leaves the vehicle, because once nobody is at the controls it is the only thing holding it.
-
42. A roadside test shows a commercial driver has measurable alcohol in the system but below 0.04. What happens?
Show answer
Answer C: The driver is placed out of service for 24 hours
Any measurable alcohol while on duty results in an immediate 24 hour out of service order, even when the concentration is under the 0.04 limit.
-
43. Which lamp must make the rear registration plate legible after dark?
Show answer
Answer C: A white lamp that lights the plate
A white license plate lamp is required so the plate can be read at night, and a burned out one is a defect like any other lamp.
-
44. Below 40 mph, what following distance does the standard commercial rule of thumb call for?
Show answer
Answer C: One second for every 10 feet of vehicle length
The base rule allows one second of space for each 10 feet of vehicle length while speed stays under 40 mph.
-
45. Why should both outside mirrors be checked over and over while backing?
Show answer
Answer B: Each mirror covers only part of the path and neither covers the blind spots, so people and objects can appear without warning
Working both mirrors in turn is the only way to follow the whole path of a vehicle you cannot see behind.
-
46. Why does the commercial driver manual tell you to look far down the road instead of only at the vehicle ahead?
Show answer
Answer D: So you can adjust smoothly instead of braking hard at the last moment
A heavy vehicle cannot react quickly, so early information lets you slow gradually rather than make a sudden stop or swerve.
-
47. The only way into a customer yard forces you to back toward the right, or blind, side of the vehicle. What should you do?
Show answer
Answer D: Use a helper and get out to check the path more often than you normally would
Blind side backing is allowed but far riskier, so it calls for a spotter you can see and for repeated checks of the path on foot.
-
48. Why should the radiator cap never be removed while the engine is hot?
Show answer
Answer A: The cooling system is under pressure and scalding coolant can be sprayed out
A hot cooling system holds pressurized coolant above its normal boiling point, so releasing the cap can throw boiling liquid and steam at whoever is holding it.
-
49. You have chosen 40 miles per hour as your safe speed for a downgrade. How should the brakes be used?
Show answer
Answer A: Brake firmly to about 35, release, and repeat at 40
Proper technique is firm application to about 5 miles per hour below the safe speed, then full release so the brakes cool before the next application.
-
50. What are you looking for when you check the drive belts in the engine compartment?
Show answer
Answer C: That each belt is snug and free of cracks, frays or heavy wear
A loose or cracked belt can break and stop the fan, the water pump or the alternator, which leads quickly to overheating or a dead electrical system.